blueroomelectronics
Well-Known Member
Next device I'm working on is a basic I/O & Serial board that can support either an Arduino, Raspberry Pi or PIC.
Brief specs.
4 Relays
4 Opto inputs
1 RS232/422/485
1 XBee socket
1 EEPROM (optional)
up to to four units can be expanded via 10pin ribbon cable (I2C).
MPU sockets for PDIP ATmega328P & PIC18F26K20 or 26pin header to Raspberry Pi
header for USB to TTL (Arduino mode or PIC bootloader)
Comments welcome.
Brief specs.
4 Relays
4 Opto inputs
1 RS232/422/485
1 XBee socket
1 EEPROM (optional)
up to to four units can be expanded via 10pin ribbon cable (I2C).
MPU sockets for PDIP ATmega328P & PIC18F26K20 or 26pin header to Raspberry Pi
header for USB to TTL (Arduino mode or PIC bootloader)
Comments welcome.
Last edited: