WARNING:current chip does not have enough common(non-banked) RAM

[Dr_Doggy]

nope, dont work, I think a register is out of line somewhere, since i will tell it to repeat print a char off the map, but it will print other chars ie ????///?????//?/?///??

 

[Dr_Doggy]

........sometimes chars not even on the map!

 

[Dr_Doggy]

ok , best i got it to work so far was with this code:

and here is what the results were, still getting errors though, and my values are a few bits off the map....?

in the data sheet it talks about commands, how would I do them?

 

[Dr_Doggy]

ok guys I figured it out, turns out the channel was not a 1 when idle, so i had to write myown TX code,


thnx again for all the help !!