theo92
New Member
Now I made a USB based IR reciever for PC...
its How-to: USB remote control receiver - Hack a Day (How-to: USB remote control receiver - Hack a Day)
Look out!!!the circyuit is easy......though the hex file is named 18F2455.hex....indicates that the hex file is for 18F2455 though i burned ir directly to 2550.....it works...the computer detects it as a 'CDC emulation device which was a microchip's application note' it adds another COM port to the PC......
But the problem here WINLIRC can't detect the device and not even responding........any other software ie uICE, Girder isnt working either..........
I'm using TSOP1356 in place of TSOP1738............I think they both're same....they both pull the output to ground in presence of IR.............
So anybody??can anybody tell me the root of the problem>>>>
ohhhh!!i forget to tell they used two 0.1uF caps in parrael to the VUSB pin.........but i'm using a 0.47 uF...will it cause some problem??
its How-to: USB remote control receiver - Hack a Day (How-to: USB remote control receiver - Hack a Day)
Look out!!!the circyuit is easy......though the hex file is named 18F2455.hex....indicates that the hex file is for 18F2455 though i burned ir directly to 2550.....it works...the computer detects it as a 'CDC emulation device which was a microchip's application note' it adds another COM port to the PC......
But the problem here WINLIRC can't detect the device and not even responding........any other software ie uICE, Girder isnt working either..........
I'm using TSOP1356 in place of TSOP1738............I think they both're same....they both pull the output to ground in presence of IR.............
So anybody??can anybody tell me the root of the problem>>>>
ohhhh!!i forget to tell they used two 0.1uF caps in parrael to the VUSB pin.........but i'm using a 0.47 uF...will it cause some problem??