Yes I got it to work on my demoboard by doing that "or" thingy , I used code for now as a buffer
"rawoff" mode works RX receives OK
when in raw voltmeter says TX makes it to gps, but no feedback(anywhere), i think its my commanding, is it as simple as typing: 00 OR do i type $00 (in the uart tool)?
tool works like hyperterminal and others,
here is my code if we think that is the problem:
THis code is to link gps through demoboard to tx/rx
portb3 = power indicator
portc5 = raw mode
portc4 = gps data pin
portb6&7 = tx/rx