Oznog
Active Member
Down to the least hi-tech part of a project, but perhaps the hardest to pull off.
I'd like a small production run, like 100 cases. It'd need a cutout or two and some holes drilled. It'd be nice to look at options like using membrane buttons on front with a printed surface.
I have made prototypes based on bare boxes out of Hammond, Serpak, etc. But I have no idea where to start with getting a custom job done. What are my options?
I'd like a small production run, like 100 cases. It'd need a cutout or two and some holes drilled. It'd be nice to look at options like using membrane buttons on front with a printed surface.
I have made prototypes based on bare boxes out of Hammond, Serpak, etc. But I have no idea where to start with getting a custom job done. What are my options?