Continue to Site

Welcome to our site!

Electro Tech is an online community (with over 170,000 members) who enjoy talking about and building electronic circuits, projects and gadgets. To participate you need to register. Registration is free. Click here to register now.

  • Welcome to our site! Electro Tech is an online community (with over 170,000 members) who enjoy talking about and building electronic circuits, projects and gadgets. To participate you need to register. Registration is free. Click here to register now.

switch between two voltage sources dependent on micro processor output

Status
Not open for further replies.
Ok so going with Les' method, if I were to connect it like this, and put a positive voltage to the gate then I would have the GND connected and so the dimming circuit would be on? Or am I misunderstanding the datasheet (https://www.fairchildsemi.com/datasheets/2N/2N7000.pdf)?
 

Attachments

  • schematic.jpg
    schematic.jpg
    174.5 KB · Views: 160
Hi SamV67,
Yes that is the correct way to connect the mosfet. It will be in dimmer mode when the gate voltage is at a logic high and at near the 24 volts when the gate is at a logic low.

Les.
 
Status
Not open for further replies.

Latest threads

New Articles From Microcontroller Tips

Back
Top