rayyolanda
New Member
Hi All, I have some small stepper motors which I want to put into a small CNC project. The motors are Japan Servo Co. KH42KM2R053 1.2 Amp 3.1/2.3 Ohm 1.8 Deg step.
Can you give me some recommendations for driving these motors? I was thinking of using a PIC and tc4423 or 4469 with FETs. I really want to Microstep these motors. As I said this is a small setup but I want to have good accuracy. I don't want to discuss the mechanics just the electronics and maybe the driving software/controller interface.
I have looked at various chips and just want some advice.
I hope someone can help.
Thanks
Can you give me some recommendations for driving these motors? I was thinking of using a PIC and tc4423 or 4469 with FETs. I really want to Microstep these motors. As I said this is a small setup but I want to have good accuracy. I don't want to discuss the mechanics just the electronics and maybe the driving software/controller interface.
I have looked at various chips and just want some advice.
I hope someone can help.
Thanks