hello guys
hope you are all fine...
well i have an idea in my mind but yet not really ready so am asking for help from my fellow experts )
i will tell you the idea abtractly:
i want to control a bunch of four servos on a vehicle or something through a joystick in my hand. the system is wired and hence i want to have the wire as thin and light as possible and this means that we need to have the number of wires going from the joystick to the bunch of servos are minimal. well in addition each two of the four servos will recieve the same command and hence we can see that generally there will be only 4 possible commands to the servos from the joystick (for each two (up and down= 2X2 =4 ))......... can you get my idea guys. i need to see what kind of circuits do i need on the joystick interface and on the servo side if i would use digital commands or so......
i need to know any feed back , help suggestions and comments on the idea, if someone really knows a site to find some similar things that would be just great.
hope you are all fine...
well i have an idea in my mind but yet not really ready so am asking for help from my fellow experts )
i will tell you the idea abtractly:
i want to control a bunch of four servos on a vehicle or something through a joystick in my hand. the system is wired and hence i want to have the wire as thin and light as possible and this means that we need to have the number of wires going from the joystick to the bunch of servos are minimal. well in addition each two of the four servos will recieve the same command and hence we can see that generally there will be only 4 possible commands to the servos from the joystick (for each two (up and down= 2X2 =4 ))......... can you get my idea guys. i need to see what kind of circuits do i need on the joystick interface and on the servo side if i would use digital commands or so......
i need to know any feed back , help suggestions and comments on the idea, if someone really knows a site to find some similar things that would be just great.