adityashanker
New Member
Hey guys,
I've been having a problem with this circuit for a few days. I needed an externally powered op-amp instead of the one without the Vcc and -Vcc terminals in Simulink (Im using Ver- R2011a). So, i looked up the internal diagram and i created my own circuit. But, the problem is, it isn't working as i want it too. Any help or ideas on this problem are appreciated
The model and the internal circuit are posted below. I'm using the opamp as a non-inverting amplifier. Btw, how do you post simulink models on this thing?
The problem is, changing the feedback resistances are not affecting the output.
I've been having a problem with this circuit for a few days. I needed an externally powered op-amp instead of the one without the Vcc and -Vcc terminals in Simulink (Im using Ver- R2011a). So, i looked up the internal diagram and i created my own circuit. But, the problem is, it isn't working as i want it too. Any help or ideas on this problem are appreciated
The model and the internal circuit are posted below. I'm using the opamp as a non-inverting amplifier. Btw, how do you post simulink models on this thing?
The problem is, changing the feedback resistances are not affecting the output.