The SwCAD universal op amp can be set up to look approximately like almost any op amp. To make it look like National's LM741, right-click on the universal op amp symbol and change the parameters. The following setup works pretty well for the circuit above.
SpiceModel level3a
Value
Value2 Avol=200k GBW=1Meg Slew=312k
SpiceLine ilimit=25m rail=1 Vos=0 phimargin=70
SpiceLine2 en=0 enk=0 in=0 ink=0 Rin=500Meg
I didn't play with ilimit or the noise params. The universal model doesn't handle recovery time from overdrive, nor does it seem to handle Rin very well (it makes no distinction between common mode Rin and differential mode Rin).
Ron
PS for AC analysis (Bode plots), you need to set the AC input to 1 volt. As with any version of Spice that I'm familiar with, the model is linearized before AC analysis, so you can't overdrive it. If you use other than 1 volt input, you have to scale the gain accordingly. For example, a 0.1V signal will plot as -20dB, a 0.5V signal will plot as -6dB, etc.