StudentSA
Member
Hi...
I am using eagle for the first time to design a PCB which I intend to Etch out. I would like to know what size should I keep my tracks to prevent any problems during etching.
Ive been using 0.25mm tracks (wires)... Is that a bit too thin?
Also I have a grid defined as 1mm with 0.1mm alt grid, is this okay because I am etching and not using any PCB fabrication place?
Regards,
StudentSA
I am using eagle for the first time to design a PCB which I intend to Etch out. I would like to know what size should I keep my tracks to prevent any problems during etching.
Ive been using 0.25mm tracks (wires)... Is that a bit too thin?
Also I have a grid defined as 1mm with 0.1mm alt grid, is this okay because I am etching and not using any PCB fabrication place?
Regards,
StudentSA