S suprith New Member Feb 13, 2013 #1 How to interface the microcontroller with the PC using the USB-UART bridge? I also wanted to display the waveform on PC with the help of matlab..
How to interface the microcontroller with the PC using the USB-UART bridge? I also wanted to display the waveform on PC with the help of matlab..
MikeMl Well-Known Member Most Helpful Member Feb 13, 2013 #2 Buy a USB serial port . Get a microcontroller with a built in serial UART. Wire the two together. Figure out a protocol to move bytes from the micro to the PC (maybe CSV?) that Matlab can read. Last edited: Feb 13, 2013
Buy a USB serial port . Get a microcontroller with a built in serial UART. Wire the two together. Figure out a protocol to move bytes from the micro to the PC (maybe CSV?) that Matlab can read.