Hi folks, I am a newbie on this.
I am trying to construct a simple circuit to measure the EMG, but so far all i got now is noise. any suggestions?
Also, how can i replace a push button with an electronic switch (relay?)?
the input signal is a pulse from an altera board, high = push, low = release.
Thanks!
I am trying to construct a simple circuit to measure the EMG, but so far all i got now is noise. any suggestions?
Also, how can i replace a push button with an electronic switch (relay?)?
the input signal is a pulse from an altera board, high = push, low = release.
Thanks!