I am trying to construct a simple circuit to measure the EMG, but so far all i got now is noise. any suggestions?
Also, how can i replace a push button with an electronic switch (relay?)?
the input signal is a pulse from an altera board, high = push, low = release.
What's EMG?. Also post your circuit, so we can see what might be wrong.
Also, how can i replace a push button with an electronic switch (relay?)?
the input signal is a pulse from an altera board, high = push, low = release.
Just connect the relay contacts in place of the switch (if you wanted to use a relay), or you could just use a transistor - but your question is far too vague, you need to give exact details of what you require.