Pete Olsen
New Member
I have an application where I am using a Servo City ST200 pan tilt camera head, driven by a QBloc Touch Screen Micro Controller.
Servo and Qbloc are being powered by an ATX PC Power Supply for 5 and 12 volts.
I am experiencing some rough movements on the pan function and would like to know if there is anything I can do to smooth this out so it is not so jerky.
Regards,
Pete...
Servo and Qbloc are being powered by an ATX PC Power Supply for 5 and 12 volts.
I am experiencing some rough movements on the pan function and would like to know if there is anything I can do to smooth this out so it is not so jerky.
Regards,
Pete...