T turbobill New Member Sep 28, 2008 #1 I have not seen any RFQs on the forum and am not sure if it is allowed or appropriate so I'll just give it a test here and see what happens. I have a schematic that I want a "Gerber" file for so I can get circuit boards made by manufacturers, etc. This is a very simple, small single-layer project that I just need to get into Eagle so I can get boards made. So if you are good with Eagle and would like to give me a quote, please PM me? Thanks, TurboBill
I have not seen any RFQs on the forum and am not sure if it is allowed or appropriate so I'll just give it a test here and see what happens. I have a schematic that I want a "Gerber" file for so I can get circuit boards made by manufacturers, etc. This is a very simple, small single-layer project that I just need to get into Eagle so I can get boards made. So if you are good with Eagle and would like to give me a quote, please PM me? Thanks, TurboBill
T turbobill New Member Sep 29, 2008 #2 Only one response so far. Doesn't anyone want to make a few extra bucks?
P Pommie Well-Known Member Most Helpful Member Sep 29, 2008 #3 Why not post the circuit, if it's as simple as you state then some posters here may see this it as a challenge and do it for fun. Mike.
Why not post the circuit, if it's as simple as you state then some posters here may see this it as a challenge and do it for fun. Mike.