Can anyone advise me on what type of DC connector/cable should be used with this component? In the spec sheet it is described as a female pin connector. Googling for a solution has proven difficult....thanks!
The SMA's have a Teflon Dielectric, the 2.92mm connectors have air dielectric and are rated to 40 GHz or K band. Although the SMA and the 2.92 mm are interchangeable, the 2.92mm is considered a precision connector used in a lab. The 2.92mm connectors are available from Mouser electronics. https://www.mouser.com/new/molex/molex-precision-compression/
As far as the DC connection goes, looks like standard solder turret and pin. Probably use a good quality shielded cable. Not sure what the best wire gauge would be.