I need to re-solder on contacts that were pulled out of the battery box. There is a simple switch (Picture attached- I re-soldered where I thought they would go in the picture) with two AA batteries powering a speaker and led box located in a Halloween Cat that vibrate and light up with a motion sensor.
I am not sure where to re-solder back on the leads. I tried to wire up the positive lead to middle connection to the switch and the battery V+ to the left connection on the switch. Then I wired the gnd lead directly to the battery gnd. (I am guessing which lead from the Halloween Cat was + and -, not sure how to check polarity) I tried hooking up the cat, but it would not work. Any ideas???
I am not sure where to re-solder back on the leads. I tried to wire up the positive lead to middle connection to the switch and the battery V+ to the left connection on the switch. Then I wired the gnd lead directly to the battery gnd. (I am guessing which lead from the Halloween Cat was + and -, not sure how to check polarity) I tried hooking up the cat, but it would not work. Any ideas???
Last edited: