Relay!!!???

Status
Not open for further replies.
Jbroadway said:
ok getting really frustrated now one of them worked last night the 3rd one was on charge all day and nothing so i switched it back to the second one and its been on charge for an hour and half now and nothing it was charged within half hour yesterday
Click to expand...

Return the timers to your supplier and get a full money refund.
 
If I attached my voltage to the wrong side of a 1n4004 will it damage it
 
Last edited by a moderator:
Jbroadway said:
If I attached my voltage to the wrong side of a 1n4004 will it damage it
Click to expand...
hi,
Do you mean if the diode was reversed or the Line wire directly to pin2.??

If yes, its possible that the unit maybe damaged.
 
no luckily the unit wasnt attached at the time it just made a big pop because 2 leads where touching and then i noticed
 
ive just realised this wont work anyway i have 22v at the unit and the timeguard person told me to use a 48v relay so 22v wouldnt be enough to pull a 48v relay would it?
 
Jbroadway said:
ive just realised this wont work anyway i have 22v at the unit and the timeguard person told me to use a 48v relay so 22v wouldnt be enough to pull a 48v relay would it?
Click to expand...

Rechecked the d/s for the MEU11, it clearly states a 48V relay for Figs 6,7 & 8.

How are you measuring the voltage.?
 

Attachments

  • AAesp01.gif
    26 KB · Views: 147
Last edited:
Jbroadway said:
how would i read that? and really i didnt know it would give a different reading?
Click to expand...

The only sure way is to use a scope.

I would again recommend that you return the Timers to your supplier and either get new Timers or a refund.
 


hi all i know its an old thread now but i have a quick question about this i have 4 of the time clocks, to power the clocks like the picture could i just use 1 resistor and 1 diode and just link them through to each clock?
 
hi all i know its an old thread now but i have a quick question about this i have 4 of the time clocks, to power the clocks like the picture could i just use 1 resistor and 1 diode and just link them through to each clock?
Click to expand...

bump?
Click to expand...

Sorry I don't understand what your trying to do, Could you post a better discription/diagram ?
 
Status
Not open for further replies.

Similar threads

S
  • Question
Low power consumption relays
2
Replies
23
Views
3K
Tony Stewart
K
  • Question
Relay Coil Diode Specs
Replies
12
Views
2K
Ken1
K
K
  • Question
Power failure relay options
Replies
2
Views
1K
kitamiman
K
F
  • Question
Relay connectors unknown?
Replies
9
Views
2K
eTech
E
S
  • Question
EV Charger relay strange behaviour
Replies
18
Views
5K
Diver300
D
Menu
Log in
Register
Cookies are required to use this site. You must accept them to continue using the site. Learn more…