praveen_kw
New Member
Hey,
This is my setup:
Im testing my program, by puttin in DC current in RA0, RA1 and RA2. what the program is supposed to do is send an output through RB0 when there is no voltage in RA0 and RA1. It worked fine at first.
But i added increased the delay time, so that RB0 would sent an output only after a certain time. with this changed code, RB0 is not sending any output.
I changed back the code to the 1st one, but now PB0 doesnt send an output.
I highly doubt there is anything wrong with the PIC, because i can download programs into the PIC from the computer, but i could be wrong.
does anyone know wut do be happening here?
This is my setup:
Im testing my program, by puttin in DC current in RA0, RA1 and RA2. what the program is supposed to do is send an output through RB0 when there is no voltage in RA0 and RA1. It worked fine at first.
But i added increased the delay time, so that RB0 would sent an output only after a certain time. with this changed code, RB0 is not sending any output.
I changed back the code to the 1st one, but now PB0 doesnt send an output.
I highly doubt there is anything wrong with the PIC, because i can download programs into the PIC from the computer, but i could be wrong.
does anyone know wut do be happening here?