Follow along with the video below to see how to install our site as a web app on your home screen.
Note: This feature may not be available in some browsers.
if connected direct ,then the pulse width will to too small!! , or use an RC delay in the delay cktRon H said:Signal into one input of an exclusive OR. Signal delayed into the other input of the XOR.
and the pulse width would depend on the input-to-output response time of the gates. won't it be too fast/ too narrow pulseljcox said:You don't need 2 ICs. Use unused sections of the XOR as the delay.
If you connect a High to one input of an XOR, it acts as a non inverting buffer.
Alternatively, if you connect a Low to one input of an XOR, it acts as an inverting buffer.
Bah! Nitpicking nitpicking. :lol: The point is they have to be out of phase.ljcox said:You don't need 2 ICs.
You can call it nitpicking if you wish, but the point I was trying to make is that an XOR can be used as either an invering or non inverting buffer.DigiTan said:Bah! Nitpicking nitpicking. :lol: The point is they have to be out of phase.ljcox said:You don't need 2 ICs.