bluesam
New Member
Dear all,
I already made the schematic here based on .GIF but the simulation's run confusing me
1. According to GIF picture it should lights the LEDs from U4 to U6
but in my schematic and simulation it runs from U6 to U4
2. It should give a linear response to every celcius from the LM35DZ; one LED lights per celcius,
but in my simulation it has not
3. The U4 bargraph LED won't light up / turn on
Would you mind to check it/simulate it in case i did something wrong in my Proteus?
thanks (*i think i'm in right room now)
bluesam
I already made the schematic here based on .GIF but the simulation's run confusing me
1. According to GIF picture it should lights the LEDs from U4 to U6
but in my schematic and simulation it runs from U6 to U4
2. It should give a linear response to every celcius from the LM35DZ; one LED lights per celcius,
but in my simulation it has not
3. The U4 bargraph LED won't light up / turn on
Would you mind to check it/simulate it in case i did something wrong in my Proteus?
thanks (*i think i'm in right room now)
bluesam