D dschmid4 New Member Aug 8, 2016 #1 I'm new to Proteus but desperately need to simulate a dual coil latching relay. Specifically, I'm using a HFD2/005-M-L2 from Hongfa. Need this to be an active component so I can run simulations. How do I go about this? Dan
I'm new to Proteus but desperately need to simulate a dual coil latching relay. Specifically, I'm using a HFD2/005-M-L2 from Hongfa. Need this to be an active component so I can run simulations. How do I go about this? Dan
Ian Rogers User Extraordinaire Forum Supporter Most Helpful Member Aug 9, 2016 #2 You make a sub circuit that contains the extra parts... Do you need a single pulse or separate on / off?? A simple JK flipflop will give both operations... One thing to remember on Proteus.... A relay or switch cannot switch in a power rail... It does not work!!
You make a sub circuit that contains the extra parts... Do you need a single pulse or separate on / off?? A simple JK flipflop will give both operations... One thing to remember on Proteus.... A relay or switch cannot switch in a power rail... It does not work!!
Tony Stewart Well-Known Member Most Helpful Member Aug 9, 2016 #3 Can you generate the SET, RESET pulses 5V 40mA for 5 ms min. ? At 200mW this should be possible to leave power on but intended for pulse operation.
Can you generate the SET, RESET pulses 5V 40mA for 5 ms min. ? At 200mW this should be possible to leave power on but intended for pulse operation.