Programming PIC16F54 with Pickit2 in MPLAB

Status
Not open for further replies.
L

lukas.ballo

New Member
I would like to use MPLAB IDE 8.30 with Pickit2 to program PIC16F54. The firmware loaded in my Pickit2 does support that chip however MPLAB IDE shows a "red dot" (meaning not supported) by Pickit2 when I select PIC16F54 as device to be programmed. Is there any way to add support for this combination (Pickit2+PIC16F54) into MPLAB IDE?

**broken link removed**
 
It's a really old part not even supported by PK2 2.61, the 16F628A is a more than adequate (cheaper too) replacement.

It is a parallel programmed PIC, you need a PICStart+ to program those.
 
Last edited:
You will have to program the HEX using the PICkit 2 Programmer software.

Under the "Device Family" tab select Baseline, and then PIC16F54 from the Device drop-down list.
 
blueroomelectronics said:
It's a really old part not even supported by PK2 2.61, the 16F628A is a more than adequate (cheaper too) replacement.

It is a parallel programmed PIC, you need a PICStart+ to program those.
Click to expand...

You're thinking of the 16C54 Bill, the 16F54 is a 'modern' EEPROM/FLASH version and is supported by the PICKit2 - it's under the Baseline series.
 

Look here: **broken link removed**
 
It a baseline chip you have to set manually I use some baseline chips mostly the 12f508
here this show you where it's at **broken link removed**
 
Last edited:
Status
Not open for further replies.

Similar threads

S
PICKIT3 not recognised in MPLAB
Replies
11
Views
3K
tumbleweed
T
P
  • Question
MPLAB X How do I make a release version?
Replies
15
Views
3K
granddad
F
  • Question
Issue with Interfacing LCD with PIC16F877A
2
Replies
22
Views
3K
Farhaad
F
K
  • Question
Help with STM32G0
Replies
0
Views
167
kostrik
K
B
  • Question
Temperature controlled fan using PIC16F877a (in assembly language)
Replies
4
Views
759
Dan Soze
D
Menu
Log in
Register
Cookies are required to use this site. You must accept them to continue using the site. Learn more…