Hello,
I would like to get some basics of how microcontrollers are programmed, the USB Bit Whacker in particular. I have learnt that these take in signals (either analog or digital) go through a computer program and out put results. My query is how they are programmed. I am doing mostly power system but found much interest in this. Would like to learn.
Have learnt some C programming at school and was wondering if this/ anyother microcontrollers can be programmed in this! How are the input and output ports located on the PC? How do you address a code to a particular port.
Need the Beginners basics.
Thanks
I would like to get some basics of how microcontrollers are programmed, the USB Bit Whacker in particular. I have learnt that these take in signals (either analog or digital) go through a computer program and out put results. My query is how they are programmed. I am doing mostly power system but found much interest in this. Would like to learn.
Have learnt some C programming at school and was wondering if this/ anyother microcontrollers can be programmed in this! How are the input and output ports located on the PC? How do you address a code to a particular port.
Need the Beginners basics.
Thanks