MrDEB
Well-Known Member
I have a CONST array written in Swordfish and am experimenting using TLC5916 as the constant sink but I need to input my data for the LED display in serial form. Is there a way to just use
PORTA.1 = %00000111 then go with portA.bits(x) = SDI or something similar??
am trying to use the timing diagram to get the TLC5916 to operate correctly.
If I can put the byte on one pin instead of 8 it would cut down on my pin usage.
PORTA.1 = %00000111 then go with portA.bits(x) = SDI or something similar??
am trying to use the timing diagram to get the TLC5916 to operate correctly.
If I can put the byte on one pin instead of 8 it would cut down on my pin usage.