Problem using TL082CP as a voltaage buffer

Status
Not open for further replies.
L

legolas

New Member
Hi all,
first post here. I am trying to design a simple voltage follower in breadboard using TL082cp opamp and the circuit is attached. However i am getting very noisy output even though the simulator worked fine.
I have connected everything as in the picture with only the ground connection is missing(did not use any ground connection) and connected the ground probe of osciloscope to the negative supply. Is there anything that i did wrong here??

Thnak You
 

Attachments

  • voltage follower.png
    25.4 KB · Views: 592
hi,
The power lines to the OPA are not referenced to 0V , it will not work correctly.
 
hi,
thanks a lot for the reply.
Can you explain a bit more. Do you mean, i need a ground for both R1 and negative supply terminal?
Also i am wondering whether a ground means connecting to earth??
 
hi,
You ideally need a +5V and -5V supply to the OPA.

Are you using the other half of the TL082 for any thing else.???
 
Ok,thanks i will try accordingly.
No, i am not using the other part and so left them unconnected.
Also do i need a ground connectin here???
 
legolas said:
Ok,thanks i will try accordingly.
No, i am not using the other part and so left them unconnected.
Also do i need a ground connectin here???
Click to expand...

hi,
Use the other half to split the 10V into +/-5V, look at this image.

When using the non inverting input such a large value of capacitor is not required.

Say 100nF and 100K.
 

Attachments

  • AAesp01.gif
    42.3 KB · Views: 418
Status
Not open for further replies.

Similar threads

F
  • Question
LTspice syntax problem
Replies
4
Views
3K
Tony Stewart
O
  • Question
Problem with TP4056 Lithium Battery Charger
Replies
1
Views
3K
rjenkinsgb
M
  • Question
help identify a component on a microphone circuit
Replies
11
Views
2K
Nigel Goodwin
printing a board using EASYEDA
Replies
13
Views
4K
MrDEB
P
  • Question
Recommend a simulator software for students that has all the components present in the circuit diagram
Replies
3
Views
2K
danadak
Menu
Log in
Register
Cookies are required to use this site. You must accept them to continue using the site. Learn more…