Hi to all,
I am facing a problem regarding the burning of program from AVR STUDIO4 in ATMEGA32 Micrcontroller through EXTREME BURNER -AVR. But while burning the following messages
are coming -
> Autodetecting programmer
> Found USBasp on USB port
> Powering ON
> Powering failed
> Cannot communicate with target chip
> Retrying again
> Power on failed
> Cannot communicate with target chip
> Repeating the above three
> Powering off
> Power turned off
> ******Task failed*******
> *******Please retry again*******
> Thank you
I have done the connections in ISP programmer according as shown in figure in the Attachment. Please check if it can be solved.
Sumanta
Indian Institute Of Technology Kharagpur, India
I am facing a problem regarding the burning of program from AVR STUDIO4 in ATMEGA32 Micrcontroller through EXTREME BURNER -AVR. But while burning the following messages
are coming -
> Autodetecting programmer
> Found USBasp on USB port
> Powering ON
> Powering failed
> Cannot communicate with target chip
> Retrying again
> Power on failed
> Cannot communicate with target chip
> Repeating the above three
> Powering off
> Power turned off
> ******Task failed*******
> *******Please retry again*******
> Thank you
I have done the connections in ISP programmer according as shown in figure in the Attachment. Please check if it can be solved.
Sumanta
Indian Institute Of Technology Kharagpur, India