Continue to Site

Welcome to our site!

Electro Tech is an online community (with over 170,000 members) who enjoy talking about and building electronic circuits, projects and gadgets. To participate you need to register. Registration is free. Click here to register now.

  • Welcome to our site! Electro Tech is an online community (with over 170,000 members) who enjoy talking about and building electronic circuits, projects and gadgets. To participate you need to register. Registration is free. Click here to register now.

Problem regarding burning program in Microcontroller

Status
Not open for further replies.

shom_show

New Member
Hi to all,

I am facing a problem regarding the burning of program from AVR STUDIO4 in ATMEGA32 Micrcontroller through EXTREME BURNER -AVR. But while burning the following messages

are coming -

> Autodetecting programmer

> Found USBasp on USB port

> Powering ON

> Powering failed

> Cannot communicate with target chip

> Retrying again

> Power on failed

> Cannot communicate with target chip

> Repeating the above three

> Powering off

> Power turned off

> ******Task failed*******

> *******Please retry again*******

> Thank you

I have done the connections in ISP programmer according as shown in figure in the Attachment. Please check if it can be solved.


Sumanta

Indian Institute Of Technology Kharagpur, India
 
You'll have to post the entire schematic for the device you're powering up, it's obvious something is very wrong and you have not provided us enough information to.

Verify all of your connections physically, do not assume they are correct.
 
Status
Not open for further replies.

Latest threads

New Articles From Microcontroller Tips

Back
Top