Problem regarding burning program in Microcontroller

Hi to all,

I am facing a problem regarding the burning of program from AVR STUDIO4 in ATMEGA32 Micrcontroller through EXTREME BURNER -AVR. But while burning the following messages

are coming -

> Autodetecting programmer

> Found USBasp on USB port

> Powering ON

> Powering failed

> Cannot communicate with target chip

> Retrying again

> Power on failed

> Cannot communicate with target chip

> Repeating the above three

> Powering off

> Power turned off

> ******Task failed*******

> *******Please retry again*******

> Thank you

I have done the connections in ISP programmer according as shown in figure in the Attachment. Please check if it can be solved.


Sumanta

Indian Institute Of Technology Kharagpur, India

You'll have to post the entire schematic for the device you're powering up, it's obvious something is very wrong and you have not provided us enough information to.

Verify all of your connections physically, do not assume they are correct.

shom_show said:

> Powering failed

Click to expand...

i don't know about EXTREME BURNER -AVR burner, but most similar devices need to "detect" target voltage in order to adapt to it.. as Sceadwian said, you'll have to double check the connections...!