.hi all i'm a newbie and this is my first job repairing stuff and i'm just used to really basic stuff, making up patch leads / setting up / keeping the PA going for our local church ps i am used to fault finding on gas c/h boilers in the uk
i have a problem with one of our 4 galaxy hotspot powered monitors they can be used on 240v or 12v so they may be useful to check voltages at different points
the monitor was dropped and now the speaker cone shows full movement and the ON led pulses on and off, both approx once per second in both 12v and 240 i am obtaining a schematic diagram to aid fault finding
jumping to conclusions is bad but it seems like on overload /shutdown problem to me but i'm just a gasman!!
any suggestions where to start and useful tools to use would be helpful
their tech department were'nt more helpful other than emailing a schematic
thanks
i have a problem with one of our 4 galaxy hotspot powered monitors they can be used on 240v or 12v so they may be useful to check voltages at different points
the monitor was dropped and now the speaker cone shows full movement and the ON led pulses on and off, both approx once per second in both 12v and 240 i am obtaining a schematic diagram to aid fault finding
jumping to conclusions is bad but it seems like on overload /shutdown problem to me but i'm just a gasman!!
any suggestions where to start and useful tools to use would be helpful
their tech department were'nt more helpful other than emailing a schematic
thanks