Ezechieltey
New Member
Currently dealing with the PLC and electrical circuit construction of SMEMA 1.2 standard. Wonder anyone heard of this b4?
This is what I am doing -> 2 machines A and B has a conveyor in between. The conveyor has 2 sensors on both end. The conveyor is controlled by an electrical circuit consist of relays and PLC to move the circuit board from SMT machine A to SMT machine B. Therefore we need to deal with some logic programing of the conveyor mechanism.
Now let us look at the PLC aspect of this thing :
- Circuit board transfer occurs when Machine A (sensor A) has board available (detected - contact closed), and machine B (sensor B) is not busy.
- Signals can occur anytime, but board transfer does not occur until both contacts r closed
- The "Board is available signal" from machine A will remain closed until board left machine A
- Ready signal remain close until board arrive mahcine B
- Board transfer cannot occur until each signal opens for 50ms.
My initial PLC ladder diagram is this :
---lA invert \l---------------------(counter1)----l
---lBl------------------------------(counter2)----l
---lcounter 1 - 50msl--------lcounter 2 - 50msl------------( condition 2)----l
---lAl--------lB invert\l------------( condition 1)----l
---lAl---------------------(restart counter 1)--------l
---lB invert\l---------------------(restart counter 2)----l
--lcondition 1l--------lcondition 2l-------(motor)-------l
--lBl-------(stop motor\)----l
--lstop motor\l----------(off condition 1\)----l
--lstop motor\l----------( off condition 2\)----l
--end--
*motor is used to move the converyor track to allow board transfer.
Can anyone help me on this PLC part?
And yea, hardware part is weird to, because I dont think I actually need relay on this. Just plug the sensor wire into PLC should be done isn;t it?
This is what I am doing -> 2 machines A and B has a conveyor in between. The conveyor has 2 sensors on both end. The conveyor is controlled by an electrical circuit consist of relays and PLC to move the circuit board from SMT machine A to SMT machine B. Therefore we need to deal with some logic programing of the conveyor mechanism.
Now let us look at the PLC aspect of this thing :
- Circuit board transfer occurs when Machine A (sensor A) has board available (detected - contact closed), and machine B (sensor B) is not busy.
- Signals can occur anytime, but board transfer does not occur until both contacts r closed
- The "Board is available signal" from machine A will remain closed until board left machine A
- Ready signal remain close until board arrive mahcine B
- Board transfer cannot occur until each signal opens for 50ms.
My initial PLC ladder diagram is this :
---lA invert \l---------------------(counter1)----l
---lBl------------------------------(counter2)----l
---lcounter 1 - 50msl--------lcounter 2 - 50msl------------( condition 2)----l
---lAl--------lB invert\l------------( condition 1)----l
---lAl---------------------(restart counter 1)--------l
---lB invert\l---------------------(restart counter 2)----l
--lcondition 1l--------lcondition 2l-------(motor)-------l
--lBl-------(stop motor\)----l
--lstop motor\l----------(off condition 1\)----l
--lstop motor\l----------( off condition 2\)----l
--end--
*motor is used to move the converyor track to allow board transfer.
Can anyone help me on this PLC part?
And yea, hardware part is weird to, because I dont think I actually need relay on this. Just plug the sensor wire into PLC should be done isn;t it?
Last edited: