Hi,
I'm new at programming Microchip, specifically - PIC16F872, which I have started with on this project.
The program works well and displays correctly, until the look-up table reaches the 188th count.
Table Start:
ADDWF PCL,1
RETLW 0x00
RETLW 0x01
RETLW 0X02 "
"
"
RETLW 0X99
RETLW 0X00
RETLW 0X01
"
"
RETLW 0x88
The counter quits at this time and no more values are read.
Is there a setting that increases the count capability to allow greater that 188 to be read, and where is it put in the code.
Thanks for any assistance.
Steve.
I'm new at programming Microchip, specifically - PIC16F872, which I have started with on this project.
The program works well and displays correctly, until the look-up table reaches the 188th count.
Table Start:
ADDWF PCL,1
RETLW 0x00
RETLW 0x01
RETLW 0X02 "
"
"
RETLW 0X99
RETLW 0X00
RETLW 0X01
"
"
RETLW 0x88
The counter quits at this time and no more values are read.
Is there a setting that increases the count capability to allow greater that 188 to be read, and where is it put in the code.
Thanks for any assistance.
Steve.