hello all,
iam building a stepper motor controller for my small CNC.i found below design which can control 2 motors per chip.http://www.dakeng.com/u2.html
but the design here uses PIC16F84 where as i have plenty of PIC16LF84A.so can i burn the same code(http://www.dakeng.com/u2source.zip) on the *LF chip.will it work?
i modified the circuit to handle more current.pls have a look and tell me if i did any mistake.
iam building a stepper motor controller for my small CNC.i found below design which can control 2 motors per chip.http://www.dakeng.com/u2.html
but the design here uses PIC16F84 where as i have plenty of PIC16LF84A.so can i burn the same code(http://www.dakeng.com/u2source.zip) on the *LF chip.will it work?
i modified the circuit to handle more current.pls have a look and tell me if i did any mistake.