Greetings. I am trying to find the specs on a Phico display D-0 94V-0. The display appears dead. All drive ccts are active. The pinout appears to be standard 14pin. 8 data, gnd, DVR, BTV, RS, RW,& E. I tried another display and one of the meter's 74HC08 buffers off-board could not handle the current. There are two epoxy covered IC's on the back of the display board. Other numbers on board are 0328_1228_P on a label and PDC2002M painted on the phenolic. This is a two line display. Any advice greatly appreciated.