Hi 3V0 I see your point. I agree on that
There must be an agreement between schematic and board. This is very important for future updates on our projects. Refer to the project number & start updating stuff.
I have used eagle, it’s nice but sprint is more
FASTER for me.
Here many are requesting designs urgently. They don't require any schematic they need the design or the PCB artwork. So no time to draw the schematic so directly drawing the PCB is the only solution that time.
There are many non standard components available, in this case the only solution is to measure the actual pin gaps & draw the component, the sprints
MEASURE RULER is really handy in this case.The
FREE ROTATING helps me to place them in any direction.
The
COPPER FILL option makes me to etch the PCB within 1 or two minutes (taking the use of surrounding copper adjacent to the track). This also very usefull when designing PCBs for amplifiers with a bigger earth tracks.
Some are asking only the PCB file & many of them doesn't have laser printers at home they all going to some communication & takes some laser printouts. The shop keepers doesn’t have the software’s installed & they don’t like to install them. Sprint
VIEW LAYOUT only 2mB & it doesn’t needs to be installed it can run in a USB pen drive & take print out in any layer that you select without varying any
RESOLUTION in the file.
It all depends on the user if user satisfy then ............