Continue to Site

Welcome to our site!

Electro Tech is an online community (with over 170,000 members) who enjoy talking about and building electronic circuits, projects and gadgets. To participate you need to register. Registration is free. Click here to register now.

  • Welcome to our site! Electro Tech is an online community (with over 170,000 members) who enjoy talking about and building electronic circuits, projects and gadgets. To participate you need to register. Registration is free. Click here to register now.

PCB Design Diptrace

Status
Not open for further replies.
It is possible to solder both sides when IC sockets are used. I use the machined-pin type, and this board was completely soldered on the top. Those pins that stick through could have been soldered on the back layer too.

Edit: If you use the machined-pin carriers without the plastic, it is even easier to solder both sides and still have a socketed IC.

finished-device_062709-jpg.54323


John
 

Attachments

  • Finished device_062709.jpg
    Finished device_062709.jpg
    63.4 KB · Views: 368
Last edited:
No harder than putting a collar on a flea.

You just need a real thin tip. I have also done other top side soldering by heating the wire/pin from the bottom and feeding the solder from the top. Pre-tinning of the pad helps, but is not required, particularly when the wire is heavy. I used that technique for some larger bridge rectifiers on an otherwise SMD board.

John
 
Status
Not open for further replies.

Latest threads

New Articles From Microcontroller Tips

Back
Top