PCB battery holder

[MrDEB]

About a year ago I viewed a video where a PCB held 2 coin cell batteries. I think the project was a volt meter?
the PCB was made so the coin batteries were sandwiched between the two circuit boards.
Anyone recall seeing this video?

 

[tepalia02]

Does not ring any bell for me. Can you remember seeing the vid in this forum?

 

[vishvajit]

any link to the video

 

[Pommie]

Sounds like a bad idea as no springs involved. Better to just use battery holders, much easier to replace as well.

Mike.

 

[tepalia02]

Here I have found a Lithium Coin Battery Module.
A simple Lithium Coin Battery Module for various Amiga Models to avoid leaking battery damages.

Lithium Coin Battery Module - Share Project - PCBWay

The Original since 2006!A simple Lithium Coin Battery Module for various Amiga Models to avoid leaking battery damagesThis work is licensed under a Creative Commons Attribution-NonCommercial-ShareAlik...

www.pcbway.com