Electro Tech is an online community (with over 170,000 members) who enjoy talking about and building electronic circuits, projects and gadgets. To participate you need to register. Registration is free. Click here to register now.
Welcome to our site! Electro Tech is an online community (with over 170,000 members) who enjoy talking about and building electronic circuits, projects and gadgets. To participate you need to register. Registration is free. Click here to register now.
What are the order codes/components that I need for the attached circuit. It only needs to be a prototype. The rapid electronics order codes would be good.
What are the order codes/components that I need for the attached circuit. It only needs to be a prototype. The rapid electronics order codes would be good.
The LED and its series resistor are the only two 'real' components on that diagram, with the possible exception of the 7-seg display - the rest are just generic functional blocks! If you want to pick out parts to buy, you need to make an actual schematic, not just a vague block diagram.
Actually, you will have problems as is. The pressure switch you are counting needs to be debounced, but then again perhaps somebody sells them with it built in.
Did you make this circuit/block diagram? Crocidile Clips? Should be some option in the 'view' pull-down that will show part names/numbers. Don't know much about the program, but most design programs have a BOM (Bil of Materials) or parts-list option.
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.
