Hello,
I'm new to the omp amp world and would like some advice on a circuit I have. The objective is to be able to tweak the pot so that I can send a signal out the opamp to a microchip's analog input pin.
In the simulation when I tweak the pot pin 1 of the opamp never changer, but the voltage going into its pin 3 does.
Any advice will be appreciated.
I'm new to the omp amp world and would like some advice on a circuit I have. The objective is to be able to tweak the pot so that I can send a signal out the opamp to a microchip's analog input pin.
In the simulation when I tweak the pot pin 1 of the opamp never changer, but the voltage going into its pin 3 does.
Any advice will be appreciated.
Last edited: