I have an LCD TV stuck in 'Service Mode' and unable to find a way to reset it via the TV set, the Eeprom is a 24LC64 (16f876).
I have a P16PRO40 Programmer but have never used it and it was built by the person who gave it to me which was some time ago.
I have a parallel lead that came with it and a laptop with a parallel port running WinXP.
I shall post a picture of the P16PRO if and when I am allowed.
A few quick questions:
1. What amp rated power source should be used
2. How can I confirm the PCB design version
3. How can I confirm the P16PRO is working
Thank-you in advance.
I have a P16PRO40 Programmer but have never used it and it was built by the person who gave it to me which was some time ago.
I have a parallel lead that came with it and a laptop with a parallel port running WinXP.
I shall post a picture of the P16PRO if and when I am allowed.
A few quick questions:
1. What amp rated power source should be used
2. How can I confirm the PCB design version
3. How can I confirm the P16PRO is working
Thank-you in advance.