Hey guys..me and my dad have started bonding more recently and its his birthday in a few days and i want to make something with him...
he bought me some parts to make a Cmoy headphone amplifer...but the tutorial on the website has a differnt board...so i cant follow the tutorial ....instead i will have to make it by looking at the schematics...
ive never made anything like this before but really want to learn and this will be a great step into DIY electronics...
if some1 could help me set this up so that me and my dad can build this i would really appriciate it...
ok so..here are the schematics
https://www.electro-tech-online.com/custompdfs/2009/07/cmoy-tangent-sch.pdf
THESE ARE MY PARTS
**broken link removed**
the pic shows
2 electrolyrtic caps 200uf 25v
2 0.1 uf polypropylene film caps (the blue ones) on them it says 400v 100nk :S
dual op amp
and the board
i didnt include the rest of the parts in the picture but are as follow
1x 10 KΩ 1/4 W metal film resistor
2x 4.7 KΩ 1/4 W metal film resistor
2x 100 KΩ 1/4 W metal film resistor
2x 1 KΩ 1/4 W metal film resistor, gain 11
and LEDS and switchs etc
basicly in the picture the board is very different so i cant just follow the instructions and the parts will be in different places...but i cant figure out where....
if some1 could draw me a diagram maybe of where each part should go
i would really appriciate it!....i really want this to work
he bought me some parts to make a Cmoy headphone amplifer...but the tutorial on the website has a differnt board...so i cant follow the tutorial ....instead i will have to make it by looking at the schematics...
ive never made anything like this before but really want to learn and this will be a great step into DIY electronics...
if some1 could help me set this up so that me and my dad can build this i would really appriciate it...
ok so..here are the schematics
https://www.electro-tech-online.com/custompdfs/2009/07/cmoy-tangent-sch.pdf
THESE ARE MY PARTS
**broken link removed**
the pic shows
2 electrolyrtic caps 200uf 25v
2 0.1 uf polypropylene film caps (the blue ones) on them it says 400v 100nk :S
dual op amp
and the board
i didnt include the rest of the parts in the picture but are as follow
1x 10 KΩ 1/4 W metal film resistor
2x 4.7 KΩ 1/4 W metal film resistor
2x 100 KΩ 1/4 W metal film resistor
2x 1 KΩ 1/4 W metal film resistor, gain 11
and LEDS and switchs etc
basicly in the picture the board is very different so i cant just follow the instructions and the parts will be in different places...but i cant figure out where....
if some1 could draw me a diagram maybe of where each part should go
i would really appriciate it!....i really want this to work