You said that your was a 16F877,, so which PIC is the one you have posted the CONFIG settings for.??
Code:
list p=16f877 ; list directive to define processor
#include <p16f877.inc> ; processor specific variable definitions
__CONFIG _CP_OFF & _WDT_ON & _BODEN_ON & _PWRTE_ON & _RC_OSC & _WRT_ENABLE_ON & _LVP_ON & _DEBUG_OFF & _CPD_OFF
; '__CONFIG' directive is used to embed configuration data within .asm file.
; The lables following the directive are located in the respective .inc file.
; See respective data sheet for additional information on configuration word.
;
; Configuration Bits
;
;==========================================================================
_CP_ALL EQU H'0FCF'
_CP_HALF EQU H'1FDF'
_CP_UPPER_256 EQU H'2FEF'
_CP_OFF EQU H'3FFF'
_DEBUG_ON EQU H'37FF'
_DEBUG_OFF EQU H'3FFF'
_WRT_ENABLE_ON EQU H'3FFF'
_WRT_ENABLE_OFF EQU H'3DFF'
_CPD_ON EQU H'3EFF'
_CPD_OFF EQU H'3FFF'
_LVP_ON EQU H'3FFF'
_LVP_OFF EQU H'3F7F'
_BODEN_ON EQU H'3FFF'
_BODEN_OFF EQU H'3FBF'
_PWRTE_OFF EQU H'3FFF'
_PWRTE_ON EQU H'3FF7'
_WDT_ON EQU H'3FFF'
_WDT_OFF EQU H'3FFB'
_LP_OSC EQU H'3FFC'
_XT_OSC EQU H'3FFD'
_HS_OSC EQU H'3FFE'
_RC_OSC EQU H'3FFF'If you are 'mixing' PIC types, this could be causing problems during assembly.
How long is the delay period you have set for TAD.?
Last edited: