Negative voltage on emitter follower

Status
Not open for further replies.

bakkis

New Member
Hi,
Iam reading horowitz and hill and came through this paragraph in section 2.03 Emitter follower :
Notice (Section 2.01, rule 4) that in an emitter follower the npn transistor can only "source" current. For instance, in the loaded circuit shown in Figure 2.8 the output can swing to within a transistor saturation voltage drop of (about +9.9v) but it cannot go more negative than -5 volts. That is because on the extreme negative swing, the transistor can do no more than turn off, which it does at -4.4 volts input (-5v output).

How will the transistor turn off at -4.4, it should have turned off much before right ? Am i missing basics of it ?

Kindly help me understand this, i'll be greatful.
 

Attachments

  • Emitter-follower.png
    3.1 KB · Views: 300
hi,
Perhaps this simulation will help you understand.

Ask if you have a problem.
 

Attachments

  • AAesp03.gif
    38.9 KB · Views: 306
When the transistor is off, the emitter and load resistors act as a simple voltage divider connected between 0V (ground) and -10V. As the two resistors are of the same value (1k) their junction point will be at -5V. Hence the emitter (which is connected to that point) wiil be at -5V. Hence the base must be at -5+0.6 = -4.4V (or less).
 
Status
Not open for further replies.
Cookies are required to use this site. You must accept them to continue using the site. Learn more…