Willie TwoFinger
New Member
I have a project that I’m working on and need a bit of direction here. I need to power 155 laser diodes rated at 650nm 5mA, 3.2 v. The diodes run at around 30mA each.
I bought this power supply
https://www.electro-tech-online.com/custompdfs/2008/05/rs35.pdf
Do I just use a triple pronged extension cord, cut off the end, then:
- place the live wire into pin 1 (L, AC) - neutral into pin 2 (N, AC) - ground into pin 3
I have a 6ft extension cord: 13A - 125V - 1625W
Or am I way off here? Any problems I need to be aware of?
Thanks for any help...
I bought this power supply
https://www.electro-tech-online.com/custompdfs/2008/05/rs35.pdf
Do I just use a triple pronged extension cord, cut off the end, then:
- place the live wire into pin 1 (L, AC) - neutral into pin 2 (N, AC) - ground into pin 3
I have a 6ft extension cord: 13A - 125V - 1625W
Or am I way off here? Any problems I need to be aware of?
Thanks for any help...