Hello,
I'm very new to analog design and I'm trying to design an integrator. The integrator should be able to integrate a 10MHz signal and it should have very low noise. I was looking at a couple of opamps and I came across AD8066. It has very low input bias current, low noise, high 3dB BW and slew rate. I also considered OPA2355 (Probably better than AD8066?). I settled on AD8066 because I couldn't run transient simulations on OPA2355. (Don't know why, but kept failing) I used LTSpice to run the simulations. The integrator seems to work but I'm a little confused by the transient response. I have attached a .asc file.
Could anyone please help me with the design? Are there general set of design rules that can be followed for any integrator design?