their is a seperate resistor to each optocouple
the statment you said were they will turn on a different increments depending on the resitance from the source is that called phase angle latching
all the scr outputs are hooked together and go to the load as one
the circuit is varible transformer 5amp and is hooked to an inductive load
i am guessing to acheive a side by side wave i will have to try different resistors on the k side of the scr like you said also would mounting each scr with its own power source instead off them all on one strip help to give me the 4 hump 50htz wave like in the first drawing
is their a type of mosfet that will give me a rounded top similar to what i had draw in the diagram ? like something used in a sinewave inverter
thanks for the help so far tonigua
the statment you said were they will turn on a different increments depending on the resitance from the source is that called phase angle latching
all the scr outputs are hooked together and go to the load as one
the circuit is varible transformer 5amp and is hooked to an inductive load
i am guessing to acheive a side by side wave i will have to try different resistors on the k side of the scr like you said also would mounting each scr with its own power source instead off them all on one strip help to give me the 4 hump 50htz wave like in the first drawing
is their a type of mosfet that will give me a rounded top similar to what i had draw in the diagram ? like something used in a sinewave inverter
thanks for the help so far tonigua
Last edited: