I'm trying to repair a high voltage 12V xenon strobe circuit, and I think one of these capacitors are bad (there's a total of 4 on the board) as one end of the capacitor was smoking when I applied power, and the underside of the board looks a little burnt on that end of the capacitor. I can't figure out the capacitor value since the marking is "106K" with "250D" below it - all of the websites online list 6 as an invalid third digit.
The size is approximately 1.156" L x 0.588" W x 0.935" H (29.36mm L x 14.93mm W x 23.74mm H).
Here's a picture of it - click on the picture to make it bigger!
**broken link removed**
Any help would be greatly appreciated! Thank you!!
The size is approximately 1.156" L x 0.588" W x 0.935" H (29.36mm L x 14.93mm W x 23.74mm H).
Here's a picture of it - click on the picture to make it bigger!
**broken link removed**
Any help would be greatly appreciated! Thank you!!