Hi All
I'm trying to connect atmel ice programmer with a 10 wire squid cable through a 1so 14 clip to an Atiny 44A , but everytime I try to connect it says the voltage is too low 0.2V
The instructions that are with the atmel ice are a little complicated for a beginner and I'm not really sure if I'm connecting to the correct pins on the chip ?
Thanks
Benji
I'm trying to connect atmel ice programmer with a 10 wire squid cable through a 1so 14 clip to an Atiny 44A , but everytime I try to connect it says the voltage is too low 0.2V
The instructions that are with the atmel ice are a little complicated for a beginner and I'm not really sure if I'm connecting to the correct pins on the chip ?
Thanks
Benji