I doubt you'll find that component specifically, but you should be able to work with the symbol and footprint for a a 3x1 2.54mm/0.100" header. That's essentially what that is.
Look for a 3x 0.1" or 3x2.54mm.
Also check for the hole size. I think the pins are square. So measure corner to corner on the square pin. Compare to the hole size for the part.
Easiest way is to just add 3 x pads, the spacing will be 0.1"/2.54mm. Adjust the pad properties to suit.
If you want to make a pattern use Pattern editor and draw some lines around the pads.
Same if you want a component but use Component editor.
Re number 2 of the pads from 1 to 2 & 3 or the editor will complain.
If you've never used the editors this will be a very easy starter project.
Most of the time I find it is easier to make up my own patterns rather than searching through the libraries.
Thank you, I found a component that I modified but rest of the circuit I had it easier to make my own patterns like you say, than using the library. Im not familiar with any standards and there were a lot different to choose from in the library...